Automatic brushing and twisting machine LJL-020

Model:LJL-020 Air pressure:1.5-2.5kg/C㎡ Twisting speed:1400circle/s Twisting length:5—80mm (150mm customizable ) Brushing motor:12v 3000circle/s Brushing wire range:0.1-10mm

Products Details

Parameters

Model

Automatic brushing and twisting machine LJL-020

Air pressure

1.5-2.5kg/C

Power

AC 220V 50Hz 10W

Twisting speed

1400circle/s

Twisting length

5—80mm (150mm customizable )

Wire range

0.1-2m㎡)

Dimension

L340×W190×H170mm

Weight

13.5KG

Brushing motor

12v 3000circle/s

Brushing wire range

0.1-10mm

Brushing stripped length

1-60mmcan be brushed up to 80-100mm depending on material of wire

Brush function: brush motor 12V 3000 rpm Brush line diameter 0.1-10 mm, brush stripping 1-60 mm (80-100 mm depending on the material) The screen brush can be scattered to one side and then twisted The density of the scattered screen should be loose and not too dense If the density of the shielding network is relatively large, you can choose another one of our company Product 1. Shield mesh disperser (can brush to 50 square meters, shield mesh length can brush to 80 mm) 2. Crawler type dispersing machine (can be brushed to 70 square meters, and the length of shielding mesh can be brushed to 200 mm) All kinds of ground wires, braided wires and isolation wires can be tightened, completely replacing manual work. The gripping hand adopts pneumatic control. When the air source is connected, the gripping hand will automatically open. When working, only need to hold the wire in, and lightly turn on the foot switch to complete the twisting operation.

Features

1.The automatic gripper adopts an exposed design, so that the scattered copper wires are also easily placed. 2.There is no need to adjust the elastic clamping wire when the wire diameter is different. 3.This model is an upgraded version of the gas-electric twisting machine. 4.The new automatic cable pulling device is added, and the training time for novices is short. 5.The opening size of the chuck can be adjusted. Loosen the chuck spindle screw inside the machine, move the entire chuck to the motor direction and then tighten the spindle screw to expand it, and vice versa. 6.The clamping force of the chuck can be increased to 5 to 6 springs by the spring force. 7.Wire range 0.1-10mm and stripping length 1-60mm can be brushed (up to 80-100mm depending on the material of wire). 8.Brush the shielding net to one side and twist the wire. The density of the shielding net should be loose and not too dense. 020singleimg (2) 020singleimg (1)

Contact us

Please feel free to give your inquiry in the form below We will reply you in 24 hours